Ridgid 50767 Model 258 Power Pipe Cutter cuts 21/2" to 8" schedule 10*/40 Steel pipegalvanized piperigid conduit etc. at the job site or in the shop. Powered by the Ridgid Model 700 Power Drivethe 258 Power Pipe Cutter is a displacement cutter that provides square cuts. The operator controls the feeding rate by pumping the hydraulic foot pump throughout the operation. A square cut With minimal burr on either 21' or nipple lengths of pipe is achieved quickly** without abrasive dustSparksor open flame. Alsothe Ridgid Pipe Roller for beveling can be used to rotate the pipe while a second operator uses a grinder to bevel the pipe. The 258 Power Pipe Cutter includes Standard equipment One Ridgid 774 Square Drive AdapterOne 8 1/2" Heavy Duty Cutter Wheel AssemblyOne Hydraulic Ram and Foot Pumpand Two 2 1/2" to 12" Ball Transfer Pipe Supports. For best results use Thin wall cutter wheel. The Model 258 is not recommended to cut cast iron pipe. For optimum wheel life always properly support the work Piece With Ball Transfer pipe supports.